SolomoSalamander
RRCRat Rig Community [Unofficial]
•Created by SolomoSalamander on 1/27/2024 in #ratos-support
Need help with: "Failed to verify BLTouch probe is raised" error during G28
Hello there!
I have a genuine BL-Touch 3.0 from Antclabs connected to a Octopus Pro 1.1 exactly as shown in the wiring diagram in /boards/ folder from RatOS.
I followed the Initial Tests on Klipper documentation. Querying the Probe gives always correct results when triggered or open. Red LED is constantly on as supposed in Antclabs Documentation.
Homing X and Y works fine, BL-Touch looks to be wired correctly, debugging tests as klipperdoc suggest is also fine.
Can you help me what I overlook?
Thank you very much for suggestions or any tips!
From electronics side I am quite sure it is okay, but I am new to RatOS and don't know where to look.
9 replies
RRCRat Rig Community [Unofficial]
•Created by SolomoSalamander on 12/11/2023 in #ratos-support
Octopus Pro 1.1 H723 - flashing will not work
74 replies