O Six
RRCRat Rig Community [Unofficial]
•Created by adverse-sapphire on 3/13/2023 in #ratos-support
Is there a solution for Mainsail that keeps failing to update?
11 replies
RRCRat Rig Community [Unofficial]
•Created by DollaTom on 3/10/2023 in #ratos-support
Flash stock - Extruder not heating at expected rate
Heater extruder not heating at expected rate
Transition to shutdown state: Heater extruder not heating at expected rate
See the 'verify_heater' section in config/example-extras.cfg
for the parameters that control this check.
15 replies
RRCRat Rig Community [Unofficial]
•Created by DollaTom on 3/10/2023 in #ratos-support
Flash stock - Extruder not heating at expected rate
Maybe your fan is spinning too fast, causing the heating head to be cooled by the wind
15 replies