jcase
RRCRat Rig Community [Unofficial]
•Created by jcase on 4/18/2025 in #fix-my-printer
Layer shifting during Skew Calibration Print - VC4 400mm IDEX
3 replies
RRCRat Rig Community [Unofficial]
•Created by jcase on 4/10/2025 in #fix-my-printer
Unexpected motion in X when moving Y
When homing Y I noticed T1 jumps (See video). I went back through the commissioning guidfe and noticed VERY small movements in the toolheads during the Y-Axis Direction test.
I inverted the directions pins for Y, which made things worse.
I feel like this could be related to tension, but unsure.
6 replies
RRCRat Rig Community [Unofficial]
•Created by jcase on 4/8/2025 in #fix-my-printer
Unable to read tmc uart 'stepper_y' register IFCNT
VC4 400mm IDEX
ERROR:
Unable to read tmc uart 'stepper_y' register IFCNT
Running through commisioning guide and getting an error with stepper_y.
I replaced the stepper with a new spare, same behavior
Then I swapped the positioning of all steppers, same behavior
I Jiggled and inspected the wire, same behavior
What is my next path for debuggin this?
DUMP_TMC STEPPER=stepper_y:
3:29 PM
Unable to read tmc uart 'stepper_y' register GCONF
3:29 PM
========== Queried registers ==========
3:29 PM
SGTHRS: 00000000
3:29 PM
TPOWERDOWN: 00000014 tpowerdown=20
3:29 PM
COOLCONF: 00000000
3:29 PM
TCOOLTHRS: 00000000
3:29 PM
TPWMTHRS: 000fffff tpwmthrs=1048575
3:29 PM
IHOLD_IRUN: 00081313 ihold=19 irun=19 iholddelay=8
3:28 PM
SLAVECONF: 00000200 senddelay=2
3:28 PM
========== Write-only registers ==========
3:28 PM
14 replies