rjnorris9533
SKSignal K
•Created by rjnorris9533 on 9/30/2024 in #questions
New user help
so i figured it out........ In the KIP app I went to the "Storage" tab along the top then selected "reset App" and the "Reset Connection" rebooted to restart Signal K and everything worked........ Thanks so much for replying and your help!!
11 replies
SKSignal K
•Created by rjnorris9533 on 9/30/2024 in #questions
New user help
ill post it again later..... I have to run to a meeting. Thanks for the help
11 replies
SKSignal K
•Created by rjnorris9533 on 9/30/2024 in #questions
New user help
did you look at the screen shot i attached to my origianl post. Cant get past this screen and get a message that says "404 cant find host"
11 replies
SKSignal K
•Created by rjnorris9533 on 9/30/2024 in #questions
New user help
and going to the WEB Apps in Signal K is how I am accessing it. It will load to DEMO mode but otherwise want to know the Signal K server address to send an verify the token
11 replies
SKSignal K
•Created by rjnorris9533 on 9/30/2024 in #questions
New user help
it is whatever Signal K setup up...... and I dont know where to look...... Ive tried 192.168.1.23:3000 and a few others that Ive found on some articale but nothing worked. Here is the funny thing it was working fine and had some dashboards setup with KIP and I did not do anything to set it up other than use the defaults however I had a problem with a OS update and did a fresh install of Raspbery PI OS, Open Plotter and Signal K and this time it didnt work.
11 replies