Pressure advance doesn't seem to get implemented
since i changed to a 0.5mm nozzle, i did some PA tests with Ellis' tool. However, the results afterwards seemed off to me. I printed this part 3 times, with PA values 0.045, 0.055 and 0.095 (to test), but the results are mostly identical. IN the PA testprint from Ellis the results do vary a lot, so i seems that the values in my cfg dont get implemented in the actual prints..
thoughts?
4 Replies
Where are you adjusting the PA?
in printer.cfg under the user overwrites
yeah, that's your problem. Most slicers override this in the start gcode
You should set this in slicer/filament profile. Add this:
SET_PRESSURE_ADVANCE ADVANCE=0.05 (whatever value you need)
If using orca, you just need to check the PA box and include the value.