VC3.1 - SuperPinda - !! Retries aborting: Probed points range is increasing. -Z-Tilt Problem
I have been struggling for some time with a problem concerning the SuperPINDA probe which is becoming increasingly annoying.
The problems mainly occur during the Z-Tilt procedure. Sometimes I have to run the print 2-3 times to get the levelling to fit within the limit of 0.012. It also happens that it is not until the 8th-9th time that the bed is leveled correctly. If the probe fails to make the correct alignment, I get the message:
"Retries aborting: Probed points range is increasing."
I therefore have the following questions:
- Could the problem lie in the probe itself (e.g. damaged or malfunctioning)?
- Is the tolerance range I have set (0.012) too small and should be increased?
- What should be the correct distance between the SuperPINDA probe and the bed for optimum performance?
Thank you in advance for your help
4 Replies
did you check that your pinda is not moving in the holder?
I put my probe 0.4mm from the nozzle so that it has maximum accuracy
I have the same issue, and my pinda is tight. My best guess is that it happens when the bed/hotend is cooling down after a print. If I start a new one immediately, it seems fine, or if I wait until it is completely cooled it's fine. But somewhere in the middle it takes several tries.
It’s super tight.It is screwed into a printed handle with a thread. The beginnings were supposed to be eddy Cool - but BTT Ignored with my problem
I have it at a height of about 1 mm from the bed