RatOS 2.1 RC and VAOC issue.
So on to next issue. I am doing this guide. https://docs.ratrig.com/v-core-4-0/idex-commissioning. At step Initial vaoc calibration. When I click on the VAOC I just get this spinning Green circle. What should I start looking at for this?
25 Replies
Not able to get pass here now.
Anyone have ideas?
Can you post what you pasted into your printer.cfg?
Or include your whole printer.cfg
sorry, and your crowsnest.cfg
One sec.
this is your log, I need the .cfg. It should be at the bottom of the main page when you got to machine. Please and thank you :)
Fan spins but no led or camera.
Everything checks out here.
when you connected the camera using the thin ribbon cable, did you make sure to align the white dots on the connecter? That cable is directional.
Will it go in both ways? I didn’t check.
It will go in both ways as far as I'm aware, but only works one way or the other.
Also wouldn’t the LED work?
LED should work without camera... Can you turn it on through the main console?
here?
Fan works but led not on. Do I need change color?
this should turn it on. If it doesnt, it's either plugged into the wrong port or not plugged in on the board.
It’s the rgb port on octopus?
Will probably have to disassemble your VAOC to further troubleshoot...
that's my best suggestion at this point :/
So cable only goes one way in pcb.
So got camera to this. But still no led.
Solution
Omg thank you! Looks like was the ribbon cable.
Great! Glad it's sorted