Bed level issue - wave in my bed mesh and copy / mirror prints on T1 result in waaaaaay to low z
Hello. I believe I have an issue with my stock bed having a wave in it. Below see the images of the hot and cold bed meshes. This results in mirror and copy prints on T1 having waaaay to low of a z offset and making mirror / copy unusable. Any and all help would be appreciated. I think I might need a new bed.
11 Replies
Cold Bed
Cold bed with sheet rotated 90*
100C normal sheet location
100C 90* rotation of sheet
you should be able to see a .7mm gap with a straight edge - so give it a check and see if it matches the bed mesh. If not, I would start investigating your X rail
will do
There is a gap 🙂
ok, did you measure it with some feeler gauges?
if you measure the bottom of the bed (where there is no magnet and flex plate to interfere) is it just as bad?
I'll take it off and check, the issue is that I have the heater pad on the bottom and the magnet on the top so trying to do that is hard
@blacksmithforlife 🇺🇸 do you want me to remove the magnet?
I'm just some random guy on the internet. You probably want to email ratrig sales and see if they will replace it