new ratos update, now cannot print
updated, received error when trying to print after update. Reflashed firmware thinking maybe there is a mismatch somewhere, updated then re-did config. Still getting the same error msg. Restored old image and it prints fine. I think it's a bug with the new update.
10:15 PM
Welcome to RatOS v2.1.0
v2.1.0-RC3-15-g6aa3c1b8
Unhandled exception during run
10:14 PM
Unhandled exception during run
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
10:14 PM
Unhandled exception during run
10:14 PM
Unhandled exception during run
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
10:14 PM
Unhandled exception during run
10:14 PM
Unhandled exception during run
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
10:14 PM
Unhandled exception during run
10:14 PM
Unhandled exception during run
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown
10:14 PM
File selected
10:14 PM
File opened:3DBenchy_0.25mm_PETG_20m38s.gcode Size:2211882
10:14 PM
Klipper state: Shutdown
10:14 PM
Post-processing unsuccessful
File is not supported, aborting...
10:14 PM
Post-processing started
Processing 3DBenchy_0.25mm_PETG_20m38s.gcode (2.11 mb)...
10:14 PM
SDCARD_PRINT_FILE FILENAME="3DBenchy_0.25mm_PETG_20m38s.gcode"
10:07 PM
SET_HEATER_TEMPERATURE HEATER=heater_bed TARGET=80
10:04 PM
SET_FAN_SPEED FAN=Raspi_Fan SPEED=1
2 Replies
Yes Blacky, I took that as saying "you need to start afresh after update as it might not work with your old configs", which i did.