How good is this mesh for a V-Core 4 500
Hello, I'm trying to make the comissioning guide to my V-Core 4 500 and I want to know how good is this mesh. Also if I can improve it, how can I do? I used the bolts to adjust in different points and also used the adjustable legs to correct some of it. Thank you in advance.
8 Replies
Your gantry is bowing upwards. Try pushing it downwards in the middle with a some force. Re-run Z tilt and a new mesh
Should i push directly the gantry? Or tightening the bolts?
Push on the gantry in the middle
Just give it a push
Thanks! I'll try and upload the new mesh
Still ... on a 500, a deviation of 0.26 - that's not bad at all. You can definitely work with that.
Agree but it's easy to straighten the gantry and you will probably get sub 0.2 and then you can just leave it
Pushed the gantry and readjusted everything. I get under 0.2 in a V-Core 4 500!
Good job 👍👊