My homing sequence seems to exclude the rear motor upon lifting to check the z.
I posted this in fix my printer but not many eyes there. This seems to be configuration related. When I first click home all three motors lower the bed. It then homes X and Y then Z goes to home only the two side motors lift and the rear stays.
https://youtube.com/shorts/BwLV4EklHzw
6 Replies
I have seen that before and the stepper wiring was messed up. Double check your rear stepper wiring
I plugged in another motor I had in that slot and pushed the home button with the same issue.
Solution
Maybe a bad driver?
yeah that is possible. Try swapping the drivers around
doing that now
That was it!!!!!!
Must have been a lady driver