Struggling to get rid of this tilt
I've been trying to correct this for days, watched the video and everything. I did put the magnetic sheet and build plate a step early. Please help!
I'm doing home->z-tilt->home->calibrate->adjustment and repeat.
9 Replies
My latest mesh.
That's abysmal. Any messages in the console when you try a ztilt?
Let me check, I just realized the beacon probe is off the build plate and reading the bed itself.
No errors during ztilt.
Ok, Now I think I can work with this. But I will take any tips 🥹
Redo your Y rails. Tighten them from one side one by one
Ans your right back is a bit high. Try to lower the corner just slighly
Ok, thanks I will give that a shot!
how would you lower that corner?
VC4 I assume? If so you are not z-tilting or something is wrong as these three spots should be on the same exact level.
