what to adjust.

Scan1 is normal, scan2 is the sheet turned 90 degrees.

chicken•8/15/24, 9:53 PM

Can you share more details about the printer? Model, size, bed leveling sensor, is this warm or cold, etc? It looks like the frame is not level and that is your problem unless the bed is not flat itself. 0.871 is pretty high if its cold

TeckgeekOP•8/15/24, 9:57 PM

V-core 3.1-500, beacon, and this was cold.

chicken•8/15/24, 10:23 PM

so for some reason that back corner was already high and you rotating the sheet made it higher. You need to figure out why it went higher but in the first place I suspect your frame is not square and thats the bulk of the bump. Check out step 3 of https://docs.ratrig.com/commissioning-guides/v-core-3-1#build-plate-preparation and watch the video as well.