VCore4 300 Hybrid
I've got a hump in my mesh but the deviation isn't that big (.18). When I use a straightedge and a flashlight I'm able to see light on the edges so am wondering if this is just "how it is" for this bed or if there's more I can do. I've verified as well as I'm able that everything is square and I've also loosened up the x-rail bolts (a torque wrench is arriving tomorrow so I can verify 0.98Nm) but so far can't seem to get it any better than this. Any ideas? I'm not (really) complaining as I can work with sub 0.2 but was just hoping for better.
Solution:Jump to solution
You could but 0.1mm on the stock bed is about as good as it gets from my understanding
7 Replies
is that with or without the magnet?
and is it the stock or upgraded bed? Not sure if that was an option on the 300mm machines
Stock bed with the magnet and not applied but just resting on top
take the magnet off and test beacon against the bare metal
Hrm - interesting - looks much better without it
Looks like just a bit of adjustment needed on the left side of my frame.
Solution
You could but 0.1mm on the stock bed is about as good as it gets from my understanding
Appreciate it.