RRC
Rat Rig Community [Unofficial]•2w ago
Serdar1976

Manta M8P v2 with cb1

Hello to all, I’m working on this trouble almost 3 days . Unfortunately, I can’t get it set up . Maybe one of you knows the solution for my problem . I running the Manta with the cb1 Unfortunately, the CB one is not booting up as long as I’m not plug-in. The jumper to the 5 V switch. I attached you to videos to explain my situation best as possible. I need help is highly appreciated . Best Regards Serdar
2 Replies
blacksmithforlife
blacksmithforlife•2w ago
Your wiring is a mess so I can't really see if you have wires the board with power correctly. Have you used a multimeter to check that the power attached to the board is actually supplying 24v?
Serdar1976
Serdar1976•2w ago
I found the reason why it didn’t work. It was because the end stop of the y axes was wrong wired.
Want results from more Discord servers?
Add your server
More Posts
Klipper reports: ERRORSection 'gcode_shell_command generate_shaper_graph_x' is not a valid configI tried the troubleshooting guide but the http://ratos.local/configure wont open *After a Pause & Resume MCU 'mcu' shutdown: Rescheduled timer in the pastDuring a print, I have pressed pause (on my klipperscreen), did some maintainance on the printed parM8P v2 mit CB1 und Ebb42 startet nichtHallo Freund, Ich brauch wieder eure Unterstützung. Ich hab hier ein Problem mit meinem Manta Board.Usb devices being reset during printDuring prints I'm losing usb connection to my tool board. Lost communication with MCU 'toolboard_t0Motors not moving on newly-build GRBL/Arduino CNC mill.Does this channel have to be for Rat Rig machines? I figured I'd ask here since there has to be somePressure advance tuning, infill weirdnessI am trying out the new pressure advance capabilities in RATOS 2.1 and am encountering an issue withAuto levelling problemHow to fix my auto levelling ?Z-offset problemI can’t fix the first layer and it always changes the Z-offset when i start it. How do i fix it?