poor surface on ASA and ABS
I’ve tried lowering solid infill thickness, slowing down, heating up, and everything I can think of. I haven’t put it in a dryer yet since the filament was fresh from factory. Otherwise I am a bit stumped.
Solution:Jump to solution
Ended up being internal solid line width got reduced (to help) but it made it worse counterintuitively
8 Replies
Do you have ironing turned on?
If so it might need to be further tuned. I got similarly bad results when I tried ironing
No. I like ironing on PLA but it didnt improve anything on ASA
I’ve tuned flow, temp, PA
What extruder/hotend combo and slicer?
Orbita v2 Rapido 2 Orca slicer. Just retuned flow, dried filament and it is still is doing it.
.4 nozzle .2 layer 8 top layers 4 walls ->1.6mm
Solution
Ended up being internal solid line width got reduced (to help) but it made it worse counterintuitively