Need some help with my print surface
Ratrig V3 400
Phaetus rapido hotend 0.6 nozzle
Orca slicer
I'm getting some error on the side of my print. I have re done presure advance. Before it was 0.050 and the new value is 0.048
but the print is the same.
Hope someone can help.
4 Replies
I have the same issue. I will follow to see if anyone has a solution.
Is this the only object you print at the same time? Or does the object have internal walls that the nozzle crosses? I had similar problems, which seemed to be caused by the nozzle “wiping” itself on the walls it crosses over. Also, my PA was way too high, I went from 0.06 to 0.03, on Volcomosq, and seemed to have quit an effect in getting rid of the issue. I also dried the filament 🙂
I just have / had a similar issue. In the standard pla profile was a flow ratio of 0.92. I changed it to 0.98 and prints look way better
Is it near the seam?