bad bed mesh v core 3.0
Hello, I have a problem with my bed mesh on my v core 3.0, how can I correct it?
10 Replies
Doesn't look all that bad - what is the range?
The range is 0.266
my normal bed mesh on voron XYZ is that 0.080. Is my first time on kinematic bed
. 266 isn't too bad but def could be better... That undulation in the Y direction would be my focus... Are you measuring the plate itself, the mag sheet, or the spring steel?
If you rotate the bed, does the undulation rotate also?
I'm measuring on the sheet but I'm going to try turning the bed to see if it changes.
I can't figure out how to improve it.
And Z TILT doesn't work properly
Retries: 0/10 Probed points range: 0.175312 tolerance: 0.200000
11:40
Making the following Z adjustments:
stepper_z = -0.006149
stepper_z1 = 0.001816
stepper_z2 = -0.007457
11:40
probe at 130.000,110.000 is z=1.581633
11:40
probe at 130.000,110.000 is z=1.581945
11:40
probe at 130.000,110.000 is z=1.582883
11:40
probe at 60.000,240.000 is z=1.414133
11:40
probe at 60.000,240.000 is z=1.414445
11:40
probe at 60.000,240.000 is z=1.413195
11:40
probe at 240.000,240.000 is z=1.553508
11:40
probe at 240.000,240.000 is z=1.552883
11:40
probe at 240.000,240.000 is z=1.552258
11:40
probe at 240.000,30.000 is z=1.406633
11:40
probe at 240.000,30.000 is z=1.406633
11:40
probe at 240.000,30.000 is z=1.407570
11:39
probe at 60.000,30.000 is z=1.527883
11:39
probe at 60.000,30.000 is z=1.527883
11:39
probe at 60.000,30.000 is z=1.527883
Z tilt works fine. Why do you think it doesn't work properly?
Your back left corner is high.
Which means you can lift your front left corner, or lower your front right corner.
ANd voila you'll have a great bed.
Choose which and do micro adjustments
And then the whole shebang.
Z, Z Tilt, Bed mesh.