polygons instead of circles n(mechanical issue)

so after some problems with my polyterra clogging up/orbiter pulverizing the filament i finally finished the print. however the part is very faceted. this is not an low poly STL issue. the failed print on the right is on my other minion. same hardware same cfg. both not tuned with input shaper. any pointers?
No description
No description
3 Replies
kakapo
kakapoOP10mo ago
*the print on the right doesnt have these issues for anyone in the future; increasing belt tension seemed to eliminate this problem, even though the tension was not necessarily low
beejayf
beejayf10mo ago
Had the same with my vcore 500 - there it was the jerk settings in my slicer - during some calibration test those were set to max 1 and I saved those as default. Should be around 7-9 If you are using Orca you can compare your current settings to some default profile - maybe it is something other than jerk
kakapo
kakapoOP10mo ago
im using superslicer's standard profile on the other printer it worked really well now it also works on this one, after tentioning the belts

Did you find this page helpful?