small gaps between layers across print. can sand it but just curious what it could be.
Using 0.4 m nozzle and 0.28mm layerheight
![No description](https://cdn.answeroverflow.com/1204915229566312488/IMG_2693.jpg)
![No description](https://cdn.answeroverflow.com/1204915230195585024/IMG_2694.jpg)
2 Replies
Could be that you are printing beyond the flow capabilities of your hotend/nozzle. Had similar prints on my setup.
Try printing a bit hotter. Try printing a bit slower. Try limiting flow in slicer.
Could also be partial clog.
I would use a smaller layer height