Communication loss to DS18B20
My printer just stopped because it lost communication with the DS18B20. The sensor is just used to check homogenity of chamber temperature, can the printer be configured to ignore the communication loss and carry on? If these sensors are that unreliable I am not comfortible to use them on the pi. Can they be attached to i.e. the octopus or an arduino nano? DS18_report_time: was default, so 3.
2 Replies
probably will have to ask on the klipper discord. I do not know of a way to ignore communication lost as I believe that is hard coded into klipper
Ok, ill retry on the klipper Discord.
Ill set this one on solved for the time beeing.