Potential pressure advance issue
I this a pressure advance issue? My infill doesn't always quite fill the gaps when it gets to the edge and I see these divets on all my prints at layer changes.
3 Replies
If you're sure it's the infill that's not filling the gaps, it's likely the infill overlap setting.
have you tried increasing your number of walls?
How to Prevent Infill Marks on the Surface of your Pieces
Understand the Key Parameters to Avoid Infill Marks.
This is the retraction setting. The marks are a spiral around the part and there appears to be one mark per layer.
What are your slicer settings for retraction? (Including seam type - random, aligned, zigzag etc.)