Difficulties with 48V stepper configuration
As the title states I'm having trouble getting configuring the steppers for both 48V and for AWD. I am not familiar with configuring either. Is there a good resource to learn from? I am getting the current error message when I try to home either the X or Y axis with only the default 2 rear motors. I have also attached my config to show how I defined the TMC 5160 parameters.
6 Replies
you have probably just forgot the set the correct jumpers for the stepper drivers
please consult your board documentation and set the stepper jumpers for SPI communication
Ah I see, I will take a look
you didn't actually attach your printer.cfg
whoops
here it is
Also Helge was indeed correct I never changed the jumpers on the stepper drivers to spi mode. Was doing some reading while at work. I'll change those over this evening and let you guys know how it goes
That fixed it! Big thanks