[solved] Move out of range at start of print
Move out of range: 553.863 142.883 0.484 [111604.695]
Occurs at start of print after prime blob. I cannot figure out why it wants to go beyond 500, bounds are set correct in slicer and config, looking inside the G-code cannot find anything suspicious. G-code attached.
8 Replies
What testing have you done? Have you tried different slicers? Is your start macro unaltered?
Start macro is just from RatOS instructions
What is the object you're printing?
Knobs for potentiometer
is this happening every time you start a print or ONLY on second print?
What about my other two questions?
Only this print in particular
I tried moving object around, but not solving the problem. I am using the RatOS start macro
Solved. It fixed itself after a RatOS update.
Great