Bed mesh does nothing
Hi I have a V-Core3 500 and the first layer is always uneven where some parts are much too close to the bed and others are too far away! I have it set up to probe 100 points with and inductive probe and it still won’t work. Any advice is greatly appreciated.
Image
4 Replies
rival-black•14mo ago
Did you get any luck with it? Im also experiencing the same issue
Also, can you post your bed mesh?
other-emeraldOP•14mo ago
Have you checked out this video? https://www.youtube.com/watch?v=h7ZTq2dDTkM
Looks like you need to slightly adjust one corner (to get rid of the tilt) and maybe loosen / reattach your gantry linear rail (to get rid of the bowing / cupping)
3D Printers & a Whiteboard
YouTube
RatRig V-Core 3: How to Get a Square Frame
This video is for those who struggle getting bed meshed with their RatRig V-Core 3.
Please feel free to jump to the chapter you are interested in.
0:00 Intro
1:05 about the v-core 3 frame and bed leveling
8:26 what to take care of in the building phase
9:17 the right square
10:09 build tips
16:50 adjusting the frame according to your bed mesh
...
Are you actually using the mesh during the print? You can check during the print, you should see the Z value changing during a layer. If that stays at the same value, the mesh isn't actually being applied.