XY motor plates not fitting well

The heads of the m5x40 screws are not entering the printed part for me like shown in the picture for the build guide. I saw this comment about removing the printed motor mount attached to the aluminum motor plate. If I remove the printed part would that mess anything up?
No description
No description
2 Replies
blacksmithforlife
That part is there to keep the bolts that the bearings go on in place during assembly. If you remove them you might have more trouble assembling the motor mounts. But otherwise it is fine, you will just have more bolt sticking up through the nuts
Vitamin G
Vitamin GOP2y ago
Thanks!

Did you find this page helpful?