Octo v1.1 flashing - klipper not detected
Hey guys I have an Octopus v1.1 on my first ratrig install and Was trying to load the firmware before connecting the machine as its not done yet. I have 24v power and usb-c connected but i get an error from ratos config stating -Octopus V1.1 detected but is unresponsive when I try to flash it. Any ideas?
3 Replies
Try to flash it through RATOS WiFi set up, you don't have to have the unit finished, in fact it is suggested you don't have anything hooked up on the original flashing.
Yes i saw that after post. I had to pull the jumpers off the board and that got me to the next step. Then klipper shutdown i presume because no heater was connected?
Thanks.