Steppers refusing to work (first time)
I just got my thermistors wired and steppers, and when I tried to home x or y I get this error, I also attached cfg.
6 Replies
other-emeraldOP•2y ago
@Helge Keck sorry it ping you again just you seem to always have an answer to my problems
@blacksmithforlife 🇺🇸 you too
check your stepper driver for z2 and make sure it is seated fully
other-emeraldOP•2y ago
what's z2?
everything in in uart mode, and not sure how to inspect my stepper drivers
also what should be seated fully?
test if the stepper driver sits correctly in its slot
do also check your crimps
9 times out of 10 this is a wiring issue - bad crimp, loose connection to board, etc... Particularly so if you are using dupont connectors
You can use the stepper buzz command to identify which motor is which
Z2 is one of the three z motors
other-emeraldOP•17mo ago
but I was moving my x motor not z