Issue with Bed Mesh
After even changing the X Gantry, and making sure its all snug and fit, to perhaps fix the valley, the bed is now double the worse, and I'm not sure why anymore.
Any insight is more than helpful. Thank you!
5 Replies
I'd first try to reduce the downward bow in your gantry... You can try playing with the torque on the bolts holding the rail to the gantry... You can also look to shims if needed...
Overall, you really aren't in a bad spot for 400 bed but I think you can improve a bit
Will try that, I've unscrewed them and retorqued them one by one from left to right.
Afterwards, I assume I'd need to push just a tiny bit A and B upwards right?
@sherbs
One step at a time... You may not need to do much after that
I did it and I gotta say its far worse. Not only that for some reason I have this waveines
Which is on the Y rails for no reason in my mind, i've tighten them as instructed, from one side to the other bolt by bolt
The waviness may, possibly, be the mag sheet... You can try rotating the bed and see if the waviness rotates along with it