[Solved] Gaps in between perimeter sharp turns
How do I get rid of these gaps? This is printed with 0.6mm nozzle, and apparently SuperSlicer doesn't care about these gaps.
8 Replies
have you tried to change the PA value a bit?
I'll try that. The PA is calibrated but it does seem slightly high, thanks
or do you have gap fil deactivated?
Gap fill is on
Such a fascinating thing, pressure advance. Not only the gaps are gone, but also the Z banding that I previously had is also gone. All I did was live adjusting the pressure advance and finding the best value. It turned out that I've been printing with too high pressure advance in a big part of my past
The Klipper square tower isn't very accurate in my opinion, it always results in too high PA
can you recommend alternative method to tune it?
print a cube and live tune it