No bridging possible
Hello,
I have a problem with my printer and I can't figure out why. It seems I can't manage to have any bridging no matter what I try.
I did try lowering the bridge speed to even 10mm/s, I did try to increase the fan to 100% ( delta fan), I did try other settings in slicer ( tried superslicer and also prusaslicer just to compare) and now I have no idea anymore what can I try.
I did try to see how the air flow is when I put the fan at 100% and I put my finger on the nozzle ( yes, the nozzle was not heated 🙂 ) and at least my feeling was that the air flow doesn't go directly on the nozzle but a like 1-2 cm in front of the nozzle.
I have a rapido uhf with the vulcano horns.
Is there anything else that I missed or I could still try? Pulling my hair here for some time and I wanted to try all I could before I asked
Thank you in advance and it will be much appreciated
3 Replies
you need to move a bit faster (not slower) to stretch the extruding plastic as well as expand the volume a tiny bit. MAX fan helps cool it so it will stretch out without sagging
In addition, you can also lower the bridge flow. With some filaments I need to go as low as 50%. Then increase flow rate over bridges by 10 or 20%
superslicer can help, it can generate bridge flow test objects in increments of 10%
will try
thank you guys
let's see what will come out