Trying to print 85A TPU
I'm trying to print 85A TPU and the first layer looks like this.
9 Replies
im using the lgx lite extruder, 0.6 nozzle, 0.2 layer height, 0.7 line width and 60mm/s speed
Did you adjust tension on the lgx?
Did you adjust nozzle size in both slicer and printer.cfg?
Did you check if it works when manually extruding via Mainsail?
yes i did all that i put it to the far right on the lgx lite the nozzle size is adjusted and it extrudes fine when im extruding it via Mainsail the e steps are also correct
thats why iam out of ideas
my last guess is that its some stupid slicer setting that iam not seeing because im blind
Do you have a profile that worked before? Try using that with the adjusted temps for TPU
And maybe restricted flow rate
Start with 5mm³/s and go up in increments
never had a profile for that tpu befoe
what temps would u recommend ?
that would be the volumetric speed option right ?
Or max flownrate
The unit should tell you which it is
Use a pla or PETG profile
ok i think i found it
ok ill try that thanks alot
is 60 to fast it prited fine and after it while it didnt extrude anymore but no skipping from the extruder and should i disable retraction
60mm/s or 60mm³/s?
my bad 60mm/s