need advice on issues I`m seeing
Hello all,
I'm hoping someone can give me any idea about what I have going on. I'm seeing many just odd and strange behavior that I'm at a loss for what is going on. I'll start with the list of odd things, then I'll give my list of things I've replaced.
At random times, with print head anywhere and I choose to Home all axis, it moves on x axis just a couple of mm stops and says no trigger on x after full movement.
If Homing actually works, (there's a reason for this and explain later on..) I run probe_calibrate, then z tilt. This is all after i level the bed manually. When I run z tilt it will go through and 1 or 2 things will happen. 1 - it will go around and eventually give up or 2 - while actually watching the z tilt run another time, the rear and front right will raise the bed but front left fails to raise.
Now that is what I've seen since I've replaced a number of parts so I'll leave it at that. I was seeing other strange things before I started replacing things.
So far here is what I've
All the drivers on the board
Brand new hot end (from another issue)
Replaced Octopus pro 446 with brand new Octopus V1.1
The rp see's the mcu fine.
I am running new Rat OS with all updates it finds.
What should I look at and/or replace next?
Thanks
Jim
1 Reply
hi for me it seems you did not have proper control of your left stepper motor? it is just on the z tilt, like can you move it with a command ?