Not sure what to adjust
Just upgraded to the Enclosed V-Core 3.1 and this is the mesh.
11 Replies
extended-salmon•2y ago
If you sure your bad is flat I would start with the worst corner, back left up? (Or front left down)
do I lower the right side at this point?
extended-salmon•2y ago
The back left looks worst to me you should. It's closer to the gantry so that corner need to go up.
I would honestly check the bed flatness on some flat surface. That is a lot to lift in your frame. I doubt it was so badly aligned... unless you just assembled it without measuring anything.
I upgraded to RR's open face it. I left brackets on and only replaced 1 extrusion at a time. That way I only had to remove 2 bracket at a time. Prior to that I the mesh was 10 times better.
extended-salmon•2y ago
Then yeah probably a frame issue
When I look at the mesh I take the red spike in the back as the back right. Is that incorrect?
extended-salmon•2y ago
Yeah y500 it's back
Sorry I just want to to do a sanity check back right is where white arrow is?
back right would be X-max Y-max . For the way your mesh is displayed there your arrow is at x-min Y-max which is the rear left corner
Thank you I would have adjusted wrong side then
That plot suggests you have some pretty substantial upward bow in the gantry... That'd be the first thing I'd look into... You'll need to correct that and get, at least, the front edge of that plot to be more flat... Seems almost 0.5mm bow in that image