Input shaper not work
Hello. I setup the klipper shaper with the ADXL345 sensor. But the shapers are not work correctly on ny V-Core 3. At the moment on x and sometimes on y axis. Acc 6k and speed 100mm. I've always had these shadows with every printer. What is wrong? Thanks all.
6 Replies
What do your input shaping graphs look like and what did you choose for
shaper_type_x and shaper_type_y?extended-salmon•2y ago
At the morning the belt measurement bar shows me on the left side 4000000 density. And the resonance shaper says 10k, After my work comming home and test, the bar shows 1000000 density and the shaper says only lower than 6k Acc. Now the resonance test says for Y zv 4% and for X mzv 0%. Klipper constantly shows me other acc and shapers.
extended-salmon•2y ago
This afternoon it was still mzv with 0% vibrations for both axes. Acc<=6600 for Y and Acc <=14400 for X. I Cant understand. It is a new sensor and new cables. The results were just as messed up with the other sensor
extended-salmon•2y ago
Now on the morning says the resonance test for both x and y axis mzv shaper with acc above 14k and 0% vibrations. X=75.4 and Y=71.2. But the tension graph shows a litle bit other frequencys.
Have you checked for any loose bolts. I know it sounds silly but when I went back and re-check my machine after a few months, I found a few loose.
Yes. But nothing is loose.