Two type of print quality on infill
I don't understand the problem
over the duports the infil is ragged on the top layers perfect
same speed 200mm/s
Using Cura slicer
Orbiter v2 Rapido hotend 0.4 nozzle
6 Replies
After print
any one has any idea??
That's a low-density bridge, tune it some and you'll get perfect overhangs. Sorry I'm using SuperSlicer, can't help more with Cura.
can you share you setting for SuperSlicer - pla
It's not material dependant.
vicious-gold•2y ago
Super slicer has an inbuilt calibration test for bridging that helps you tune these settings too. Worth a look if you don’t mind the UI.