New hot end, incorrect temperature reading with hotend off..
Continued..
5 Replies
mere-tealOP•2y ago
The PT1000 is labelled on the thermistor wire..
so it possibly needs to be set to another hotend type in printer.cfg.. it's the only thing I can think of..
it should not be connected on teh same port, and the rapido cfg does not match
pt1000 is a whole diffent story
mere-tealOP•2y ago
that would make sense.. I double checked RATRIG's wiring diagram.. don't see any note on this..
is what you need to add
mere-tealOP•2y ago
I'll give that a go. Thanks blacksmith!
That did the trick! Thanks again!