What would cause this?
Other than shown, this print is a great print everywhere else... printed at 0.1 layer height.. trying to fine tune finer prints.. anybidea what the issue was here?
3 Replies
foreign-sapphire•3y ago
you talking about the bubbles? Probably pressure advance. Have you tuned that?
Hey AirmanEpic. I have tuned in pressure advance.. it may be hard to see from the photo but it's not so much bubbles as much as it's just rough.. like a if though some one grabbed some sand paper and have that spot a sanding...
Too much heat radiating from the bed maybe. What’s your bed temp?