LDO Input Shaper Toolkit Reports Invalid adxl345 id (got ff vs e5)

Having issues getting the LDO version setup with my V Minion. Just used the same toolkit on my Voron V0.1 and it work just fine. I uncommented [include config/boards/rpi/config.cfg] and include config/printers/v-minion/input-shaper-single.cfg] in printer.cfg. Currently running the updated version of RatOS 2 Alpha so I know there could be a related bug.

Any thoughts?

beejayf•2/13/23, 11:09 AM

Check your wiring - I had a 0 vs. E5 and unplugged the cable to check and then got an ff vs. E5. My guess woukd be your sensor does not respond at all.

RSharpe•2/17/23, 11:56 AM

the ldo board connects directly to the pi doesn't it?

beejayf•2/24/23, 3:03 PM

I connected it to the BTT Octopus 1.1 but I have seen tutorials with direct to pi wiring