motor uart not connecting
My right z motor doesn't run when commanded it just locks up. Swapped plugs and drivers around until I was confident that it wasn't the motor, driver or the wiring. Attached is the error I get. Jumpers are set correctly. Is there any solution or should I assume my driver slot is bad and use a different one?
5 Replies
If it's neither the jumpers, the drivers, the wiring or the stepper, then yes, assume the slot is bad and use a different one.
Alright, new board is on order. Are the other 2 middle slots assumed to be e1 and e2?
which board?
Btt octopus pro f429
New board on order is a 446, I used to run rrf. Apologies for the late response, working currently.
No, I believe octopus board treats all drivers as generic steppers and nothing is specifically designated for extruders