ratos.local showing blank page
I just installed ratOS 1.2.4, did the configuration and wifi connection, now i'm getting a blank page on the ratos.local browser page. As such I can't install the controller board firmware.
19 Replies
Oh. apparently it just doesn't work on my desktop/laptop. Okay.
I would also use the IP address instead of ratos.local - it just works better
Didn't work when I tried that after. Still blank page.
Weird
I even plugged in directly with an ethernet cable. Still blank.
And you tried different web browsers?
Yup. Chrome, ff, edge
Far as I can tell I followed the instructions verbatim and I can't seem to get the firmware to flash either. It stays as a .bin file in the SD card.
One problem at a time. Are you connected via the ratos hotspot or your router?
I got through there and was able to get the pi connected to the wifi. RatOS hotspot disappeared after that.
Ok, so if you were able to connect via the hotspot and it wasn't blank in your browser it sounds like your router is blocking it or doing something funny
yeah?
What IP address are you connecting from?
192.168.50.1
And what's the IP address of your pi?
^that's the pi, sorry
That's only valid when it is hosting the hotspot
You need to look in your router to find the current pi IP address
ah
okay using that then yes I can access it from the desktop/laptop. Thank you
now about the firmware flashing, haha
New post please
okay