Baer
TTyperactive.xyz
•Created by waitwhat on 3/23/2025 in #🛟-help
Help building no solder board
Maybe late here to the game, but assembled mine just a week ago with the no-solder headers.
You should use the headers in a different bag, from the side the pins look kind of like triangles (that's the springing mechanism). So don't use the headers that doesn't have this "spring setup".
Use only those with springs.
I had to fiddle a little with the battery cables when i was going to mount the plate for the switches, since if the cables was under the plate, it would bend and so the switch wouldn't fully get inserted.
Side note, i had to push down my microcontrollers after a while of use since i did alot of firmware updates, and was a little to hard handed with the usb-c cable.
Noticed this when some buttons didn't work.
13 replies
TTyperactive.xyz
•Created by Baer on 3/21/2025 in #🛟-help
Can't add more layers using ZMK (corne 6 col)
It was high up on the list, so kinda hard to miss 😋 .
But thanks anyway, and also for showing something was wrong on my side.
12 replies
TTyperactive.xyz
•Created by Baer on 3/21/2025 in #🛟-help
Can't add more layers using ZMK (corne 6 col)
So, the problem is solved.
12 replies
TTyperactive.xyz
•Created by Baer on 3/21/2025 in #🛟-help
Can't add more layers using ZMK (corne 6 col)
@bk i tried out your repo before writing here in the first place. But it was ZMK Studio that thought only 3 layers existed. But when i turned this off in the conf file, i could use all layers as intended.
12 replies
TTyperactive.xyz
•Created by Baer on 3/21/2025 in #🛟-help
Can't add more layers using ZMK (corne 6 col)
Solved my problem by turning off ZMK studio in .conf, since i rather do my changes directly in my repo.
12 replies
TTyperactive.xyz
•Created by Baer on 3/21/2025 in #🛟-help
Can't add more layers using ZMK (corne 6 col)
It seems like ZMK studio is the villain here. I guess ZMK studios settings are saved somewhere on the microcontrollers and are taking priority.
Figured this out when i spammed the "+" button and saw my layers being added with correct names and mappings...
12 replies
TTyperactive.xyz
•Created by Baer on 3/21/2025 in #🛟-help
Can't add more layers using ZMK (corne 6 col)
@TyperAI Are there any keymap file examples that utilize more than 2 layer buttons and more than 3 layers?
12 replies