noobfire2
UBUniversal Blue
•Created by noobfire2 on 9/28/2024 in #🛟bazzite-help
Legion Go Gyros not working
Hey 👋🏻 Thank you for your amazing work. Today my Legion Go arrived and I installed bazzite-deck on it.
I'm on Bazzite 40, stable, Kernel 6.9.12-205, BIOS N3CN35WW, Steam Version 1726683985.
HHD is already preinstalled, version 3.3.15, GUI Version 3.2.1, TDP Adjustor version 3.4.7.
I'm using Dualsense Emulation and everything works, so touchpad, general controls and with Dualsense Edge Emulation even the back buttons are interpreted as dedicated buttons and it works.
Unfortunately gyros (& the "FPS mode" mouse sensor of the right controller) don't work at all, with either Dualsense emulation setting and regardless of when I choose Left, Right or Both Controllers and Gyros devices.
The Gyro Calibration Tab exists in Steam Game mode but it unfortunately just reads plain 0s in all axes, constantly. Even if I'm shaking them furiously. The controllers are detached then of course.
EDIT: I just also reset the controllers by both inserting a pin in the hole of the side for the controller (did just briefly turn off and on again) and by pressing & holding Legion L + LB + LS (did vibrate, fully turn off and change the RGB color to green). But after that and even reconnecting, still no change; gyros still show 0.
10 replies
UBUniversal Blue
•Created by noobfire2 on 7/25/2024 in #🛟bazzite-help
eGPU stuck on 800MHz
Hello 👋
I'm currently using a Minisforum UM790 Pro (https://store.minisforum.de/products/minisforum-um790-pro) with an ATG UT3G USB4 eGPU board (https://www.adt.link/product/UT3G.html). A RX7600XT is plugged into that. The eGPU board is obviously plugged into one of the front USB4 ports. Monitor is plugged via HDMI into the eGPU, NOT into the Minisforum PC.
Booting & having a display output works without a problem. The eGPU board enables itself properly on boot of the PC, power supply is spinning up, etc.
In games however I have extremely low FPS (way lower than with the onboard 780M) and the monitoring overlay reports that the GPU is on 800MHz constantly and only using ~3-10W.
How can I make sure that games are properly using the eGPU and fix the issue of it being only at 800MHz? It feels like the eGPU is using way more power than reported, at least all the fans (of both the GPU & the power supply) are spinning up and you can feel some heat coming from the whole setup.
Thanks a lot 🙂
6 replies