skainswo
TTyperactive.xyz
•Created by skainswo on 2/4/2025 in #🛟-help
How to set up Miryoku on Corne 6x3?
I can share with you if you'd like
9 replies
TTyperactive.xyz
•Created by skainswo on 2/4/2025 in #🛟-help
How to set up Miryoku on Corne 6x3?
So this is what I'm working on now... Afaict from reading the source there's not a clean way to configure the other column. I'm prob going to "eject" from the existing codebase and write my own miryoku zmk implementation
9 replies
TTyperactive.xyz
•Created by skainswo on 2/4/2025 in #🛟-help
How to set up Miryoku on Corne 6x3?
So far I like it! I'm not sure about the symbols later yet, but I think the general design is really solid and easy to use/remember
9 replies
TTyperactive.xyz
•Created by skainswo on 2/4/2025 in #🛟-help
How to set up Miryoku on Corne 6x3?
Update: nice!nano was seated one pin off on the hotswap headers
9 replies
TTyperactive.xyz
•Created by skainswo on 2/4/2025 in #🛟-help
How to set up Miryoku on Corne 6x3?
I should note that I also saw similar behavior with the stock ZMK keymap, so I doubt that this is Miryoku specific
9 replies