ono
VCVPforce Controls
•Created by ono on 1/10/2025 in #🧰support
Hello, I have some issue with the usb
I took a closer look at the USB socket. There seems to be an electrical short circuit. I saw it flash. I'm going to buy a new USB port. I think that will solve the problem. I'll let you know if it still exists.
11 replies
VCVPforce Controls
•Created by ono on 1/10/2025 in #🧰support
Hello, I have some issue with the usb
So I have found out that if I wobble on the usb port (connection to the FFB), this error occurs. I suspect a fault with the USB port. I'll take a closer look at this tomorrow. There may be a short circuit or a broken cable. Then get back to me tomorrow. Have a nice evening.
11 replies
VCVPforce Controls
•Created by ono on 1/10/2025 in #🧰support
Hello, I have some issue with the usb
I have a multimeter and could take measurements
11 replies
VCVPforce Controls
•Created by ono on 1/10/2025 in #🧰support
Hello, I have some issue with the usb
As soon as I plug in the usb, the green LED lights up and a beep is heard. A short time later the error message from Windows comes and the led goes out. If I unplug and put it back in, it works again. Sometimes longer, sometimes shorter
11 replies
VCVPforce Controls
•Created by ono on 1/10/2025 in #🧰support
Hello, I have some issue with the usb
I'm on my way right now, would like to test it tomorrow. Can you give me an introduction.
11 replies
VCVPforce Controls
•Created by ono on 1/10/2025 in #🧰support
Hello, I have some issue with the usb
Yes, first time. I have disconnected all. But no change.
11 replies
VCVPforce Controls
•Created by ono on 1/10/2025 in #🧰support
Hello, I have some issue with the usb
Motors and potentometer. But I try with disconnecting motors and grip. Same thing.
11 replies