WingOver
WingOver
VCVPforce Controls
Created by Dr. No on 1/18/2024 in #🧰support
I look forward to your settings ☺
Update: To use Auto Pilot Alt Hold + Special-F14-Use FFB Trim Implementation - You must set your Pitch&Roll Curves in DCS to 0. This only fixes the Auto Pilot Alt Hold issue; Case 3 Auto pilot is still challenged.
8 replies
VCVPforce Controls
Created by Dr. No on 1/18/2024 in #🧰support
I look forward to your settings ☺
F-14 - Auto Pilot Alt Hold NOT working for me at this time. Addition testing: DCS 2.9 Beta MISC Tab - Force Feedback - Checked Special - F-14 - Use FFB trim implementation - checked TelemFFB On or Off If you are having issues with F14 Auto Pilot Alt Hold, recommend you UNCHECK - DCS->Special->F14->Use FFB trim implementation until we find someone with a VPForce Rhino with it working that can share their config or a future patch is released by ED.
8 replies
VCVPforce Controls
Created by Dr. No on 1/18/2024 in #🧰support
I look forward to your settings ☺
Initial testing: DCS 2.9 Beta MISC Tab - Force Feedback - Checked Special Tab - F-14 - Use FFB trim implementation - NOT checked Controls Tab - F-14 - Pilot - FFB device (VPForce Rhino FFB) - FF Tune - Timmer Force =100, Shake = 0 VPForce FFB Configurator - Settings - Spring = 0 VPForce FFB Configurator - Effects - Spring = NOT checked TelemFFB = all default With the above settings I can fly and generally set the Auto Pilot Alt Hold on a 'trimmed' bird. ------------------------------------------------------------------------------------------------------------------- Note: Special - F-14 - Use FFB trim implementation - checked - is NOT working for me yet, still troubleshooting.
8 replies
VCVPforce Controls
Created by walmis on 12/1/2023 in #🧰support
You can test the internal connections by
Having a similar issue with the same connection point/connection in the base. Using a VIRPIL VFX Grip when I install it in my WarBRD base with the extensions it works fine, when I move it over to the VPRhino I get intermittent disconnects (debug tool worked great for diagnostic). Same issue with a VPC Constellation ALPHA with and without extensions. Is it possible there is a supply issue with the 5pin female in the VPRhino base? Is the female connector in the VPRhino a DYI able repair? I 'adjusted' the pin spacing on the 5pin male for better connection pressure, for a temp fix, don't know how long that will last. @walmis
2 replies