2 months in, Still no good first layer
I’m truly At a loss with this vcore 4. I have had it for 2 months and I still cannot get a good first layer. I’ve tried what seems like everything.
The first layer squish has to ve changed every single print. Regardless of how long I’ve heat soaked. I’ve heat soaked for 2 full hours now and I’m still having the same issues as if I heat soaked for 25 minutes. I have been printing a 490x490mm single layer sheet on the bed to get a good idea of how the offset changes throughout a print. The most recent print, I heatsoacked for 2 hours at 80C, then started the 490x490 single layer. It started in the front right corner, I set the x offset, and let it print fully. About 1/4 of the way through its print across the plate, the Z offset seemingly changed and the entire rest of the print was WAY too close to the bed. So much so that I cannot remove the layer that it printed.
I have read the other posts about similar issues but nothing that worked for other people seems to work for me. I have to be missing something. The first
I have read the other posts about similar issues but nothing that worked for other people seems to work for me. I have to be missing something. The first
0 Replies