Ratos 2.x
So I thought I had made progress. Long story short, memory card or the pi 3 crashed, so replaced with a pi 4 and new memory card. Had issues with Beacon calibration, but finally got past that. This is vcore 3. I have used superslicer since I got this. I chose something small to test print and I can't get it to start a print, not sure why. I'm using the same settings and same version of superslicer as I did before without any issues. Can someone point me in the right direction as to what in the world is happening here?
Oh, 1 more thing I'll add, I didn't have the Beacon on previously, new since the crash. So that is the only physical change, which means it's Rat OS 2
3 Replies
"Unable to parse move" is weird. Did youdouble check the slicer post-processor?
And are you on ratos 2.0.2 or 2.1?
I'm on RatOS 2.1. I haven't changed anything in my slicer. And that is the only printer that I use super slicer on. I have another printer but I use Cura for that one. I didn't know there was a post processor section of the slicer. Once I had it up and working I left it.
Check this out, see if you need to change anything
https://os.ratrig.com/docs/slicers/#super-slicer