Checkered/transparent pattern on LOD chunks

Also a decently large gap between LOD and rendered chunks. Happens with or without shaders.
No description
5 Replies
Miki_P98
Miki_P983d ago
/overdraw
YAGPDB.xyz
YAGPDB.xyz3d ago
Q: There are holes at the edge of vanilla Render Distance, especially during movement A: This is caused by either vanilla terrain not loading in fast enough, or shader's incorrect overdraw prevention implementation or configuration (if you use one) Some world gen speed improvement can be found when adding these three mods, but the affect will be minor: - Noisium - Faster Random - C2ME (DH 2.3.0+) The easiest fix is to move slower and/or ignore it. This hole is most visible while moving over not generated (by vanilla) terrain. Moving over that terrain every subsequent time may not create the hole. And moving slower will give MC more time to load the chunks as you go. If none of that helped, you can also tune the overdraw prevention, look at the third section to know how. Q: There are low quality full blocks behind and around non-full block, e.g. fences or ladders A: This is intended behavior, to prevent holes in the world while you move, DH will overlap with some part of the vanilla terrain. How much of the terrain is covered is determined by the overdraw prevention: 1.0 will mean DH LODs start where vanilla chunks end. 0.1 will mean that DH render very close to the players position. 0.0 sets it on auto mode. To fix this, you can either: Increase your vanilla RD, which will move the DH LODs further from you. Tune the Overdraw Prevention setting, see the next section to know how. Q: Where do I edit the overdraw prevention setting? A: Overdraw prevention setting can be edited inside the DH config under: Advanced > Graphics > Quality But if you use shaders, they will override and take control of the overdraw prevention. In that case, check the shader's settings, if overdraw prevention is not there, contact the shader devs or change the shader you use.
Miki_P98
Miki_P983d ago
Section 1
kitty
kittyOP3d ago
Yeah, i did find this searching for answers, but the overdraw prevention setting isnt showing even with shaders disabled. if the setting isnt there would changing the setting via the TOML have an effect at all?
This is fine
This is fine3d ago
yeah its under culling

Did you find this page helpful?