RRC
Rat Rig Community [Unofficial]•2mo ago
Rigattoni

Second EBB42 toolboard: Not able to setup.

Hi, I´m running into an issue with getting a second EBB42 toolboard installed. I had to buy a new one because I ripped off the USB socket of this board by accident. Can someone please help me with that issue???

Console_output.txt

Solution:
Well tried that first but with no luck... Tried the manual way as in the past before using RatOS... and failed too. I now used the configurator once again setting again to IDEX and chose fresh install. Now it worked as expected and the second EBB42 is recognized: ``` pi@ratos:~ $ ls /dev/serial/by-id/*...
Jump to solution
2 Replies
blacksmithforlife
blacksmithforlife•2mo ago
Why are you not using the configurator to flash the board?
Solution
Rigattoni
Rigattoni•2mo ago
Well tried that first but with no luck... Tried the manual way as in the past before using RatOS... and failed too. I now used the configurator once again setting again to IDEX and chose fresh install. Now it worked as expected and the second EBB42 is recognized: 
pi@ratos:~ $ ls /dev/serial/by-id/*
/dev/serial/by-id/usb-Beacon_Beacon_RevH_02C709225154364134202020FF153432-if00
/dev/serial/by-id/usb-Klipper_stm32g0b1xx_btt-ebb42-12-t0-if00
/dev/serial/by-id/usb-Klipper_stm32g0b1xx_btt-ebb42-12-t1-if00
/dev/serial/by-id/usb-Klipper_stm32h723xx_btt-octopus-pro-h723-11-if00
pi@ratos:~ $ ls /dev/serial/by-id/*
/dev/serial/by-id/usb-Beacon_Beacon_RevH_02C709225154364134202020FF153432-if00
/dev/serial/by-id/usb-Klipper_stm32g0b1xx_btt-ebb42-12-t0-if00
/dev/serial/by-id/usb-Klipper_stm32g0b1xx_btt-ebb42-12-t1-if00
/dev/serial/by-id/usb-Klipper_stm32h723xx_btt-octopus-pro-h723-11-if00

Did you find this page helpful?